NOTE: This is a 3.3V Shield, Only Use it with a 3.3V Arduino Variant!Tutorial Can Be Found HERE.Bluetooth
Shield, a serial port Bluetooth module (Mas..
Ever wanted to connect your Arduino or electronics project to a phone or computer over Bluetooth then this is the perfect module for you. The HC-06 bl..
The mega menus use the page builder interface and this means you can add any layout module in your menus to build the desired layout in any rows and columns combination.
This cheap and effective RF link kit is a great way to add communication between your microcontroller projects. These module operate at 315MHz and depending on configuration(antenna, power, surroundings) can operate from 10-100 M. This kit consists of one transmitter and one receiver. Receiver:
..
This
kit allows you to add RF remote control to your microcontroller
project. With the 4 button remote this lets you control up to 4 outputs
on the receiver module. The receiver has a built in decoder matching
the transmitter so no need to configure or write any of your own code,
simply monitor..
This cheap and effective RF link kit is a great way to add communication between your microcontroller projects. These module operate at 433MHz and depending on configuration(antenna, power, surroundings) can operate from 10-100 M. This kit consists of one transmitter and one receiver. Receiver:
..
This cheap and effective RF link kit is a great way to add communication between your microcontroller projects. These module operate at 433MHz and depending on configuration(antenna, power, surroundings) can operate from 10-100 M. This kit consists of one transmitter and one receiver.Receiver:
O..
The
ENC28J60 Ethernet Module is a stand-alone Ethernet
controller featuring a large number of features to handle
most of the network protocol requirements. The board connects directly
to most microcontrollers wover a standard SPI interface. Perfect for
connecting your Arduino or other microcont..
This
is the cable and antenna you need if you are looking to extend the
range of your ESP8266 module with onboard SMA connector. This kit comes
with both the cable needed (16cm) and the matching 2.4GHz antenna...
NOTE: This is a 3.3V Shield, Only Use it with a 3.3V Arduino Variant!Tutorial Can Be Found HERE.Bluetooth
Shield, a serial port Bluetooth module (Master/Slave) breakout board.
You can choose ARDUINO's Digital PIN D0->D7 as Software UART to
communicate with Bluetooth Shield(and D0,D1 also is Ha..
Have
you ever wanted to connect your Arduino or electronics project to a
phone or computer over Bluetooth then this is the perfect module for
you. The HC-05 offers both Master and Slave mode. Features: Wireless serial Bluetooth communication Standard Seria..
If
you have a serial bluetooth adapter like the HC-05/6/7 without the
backplane and would like to add it this is perfect for you. This
backplane allows your compatible bluetooth module to have an easy pin
out and function at a a 5V power level...
Ever wanted to connect your Arduino or electronics project to a phone or computer over Bluetooth then this is the perfect module for you. The HC-06 bluetooth module operates in slave mode meaning the pairing process must start from another device such as your phone or computer, this does not need to..
Trying
to set up bluetooth connects, or other RF connections can be difficult.
However the standard serial protocol is much easier to use. This RF
module has simple set up and can act as an "invisible" wireless rf link
between two microcontrollers. This unit has flexible settings for baud
rate,..