2-3 Days
Model: MV-1021
This
pulley is perfect for building your 3D printer, GT2 is the new
recommended belt type for 3D printers as it reduces backlash and is
intended for linear motion. This pulley includes 2 set screws.Features:Material: AluminumNumber of Teeth: 16Width(belt slot): 6mmBore: 5mmSet Screws: M4(2 i..
$2.49
2-3 Days
Model: MV-0824
This
pulley is perfect for building your 3D printer, GT2 is the new
recommended belt type for 3D printers as it reduces backlash and is
intended for linear motion. This pulley includes 2 set screws.Features:Material: AluminiumNumber of Teeth: 20Width(belt slot): 6mmBore: 5mmSet Screws: M3(2 ..
$2.49
New
2-3 Days
Model: MV-1023
This
pulley is perfect for building your 3D printer, GT2 is the new
recommended belt type for 3D printers as it reduces backlash and is
intended for linear motion. This pulley includes 2 set screws.Features:Material: AluminumNumber of Teeth: 20Width(belt slot): 6mmBore: 8mmSet Screws: M3(2 i..
$2.49
2-3 Days
Model: MV-0638
This
is version V1.2 mechanical end stop, it allows you to detect when your
3D printer has reached the X/Y/Z minimum or maximum. Wired so when
activated, it pulls the signal to LOW. Includes an on board LED to
indicate when the switch is activated.<..
$2.99
2-3 Days
Model: MV-0584
<p> This is a dual voltage heatbed for your 3D printer. It can run at either 12V or 24V and measures 214mmx214mm<br><br><span style="font-weight: bold;">Specifications</span>:<br></p><ul><li>Dimensions 214mmx214mm <..
$17.99
2-3 Days
Model: MV-0640
This optical endstop allows you to detect when your
3D printer has reached the X/Y/Z minimum or maximum. Wired so when
activated, it pulls the signal to LOW. Includes an on board LED to
indicate when the switch is activated...
$3.99
2-3 Days
Model: MV-0583
RepRap
Arduino Mega Pololu Shield, or RAMPS for short. It is designed to fit
the entire electronics needed for a RepRap in one small package for low
cost. It is based on the powerful Arduino MEGA platform and has plenty
room for expansion. The modular design includes spots to plug in
stepper dr..
$17.99
2-3 Days
Model: MV-0322
>If
you have lost, broken, or damaged your adapter board or cables from
your 2004 or 12864 Controller for your 3D printer then this is the
replacement you need. Please note, the cables length is 20cm, some
controllers come with 30cm cables so these may be shorter...
$4.99
2-3 Days
Model: MV-0909
Have
you Ever wanted to run your RepRap from an SD card? Here is your
chance! This RAMPS add-on enables you to print from micro SD. This
module runs at 5V and plugs directly into your RAMPS shield...
$6.99